PIRIT Heated Hose
PIRIT Heated Hose

share this page


Series II Heated Hose

Pirit Heated Hose is used to provide a constant source of water in freezing temperatures. Now available in approximately 12', 25', 50' and 100'. 12'–$89.95, 25'-$109.95, 50'-$149.95, 100'-$219.95.


Standard delivery 7-10 Days

PLEASE NOTE: Orders placed after 3PM Eastern Standard Time will be shipped on the following business day. This applies to all orders and all shipping methods, including expedited (overnight, 2-day or 3-day shipping).

Features & Benefits

  • Cold Weather Water Hose
  • Thermostatically Controlled, turns on when temperatures are below 45° F, off when temperatures are above 50° F
  • Pirit Hose has been tested to -42 degrees F (-41 degrees C )
  • Grounded Power Supply
  • Grounded Nickel Plated Brass Female and Male Coupling
  • Protective Bend Restrictors at both ends
  • Abrasion Resistant Cover
  • Knit Reinforcing
  • Heater wires are extruded directly into the hose walls for uniform heating and unrestricted water flow
  • Certifications: UL listed, MET approved, FDA approved materials
  • One-Year Warranty

Technical Specifications

IMPORTANT: This hose is for normal farm and garden use and light commercial use only.


12' (1/2" inner diameter) 90 watts .75 amps 120 volts 60 hertz
25' (5/8" inner diameter) 180 watts 1.5 amps, 120volts, 60 hertz
50' (5/8" inner diameter) 360 watts, 3.0 amps, 120volts, 60 hertz
100' (1/2" inner diameter) 500 watts 4.50 amps 120 volts 60 hertz

Do not attempt to cut or splice hose—serious injury may result.
Do not spray water into an electrical outlet. Severe electrical shock could result.

Care and Use

  • Simply unroll the hose to use just as you would a normal garden hose.
  • Screw the female end (near the electrical cord) of the hose onto your faucet. Make sure the washer is in place inside the female coupling.
  • Plug the 3-prong cord into a Ground Fault Circuit Interrupter (GFCI) or a properly-grounded 3-hole outlet that is protected by a GFCI.
  • The heater is thermostatically controlled and will not turn on unless the ambient temperature approaches freezing temperatures.
  • It is good practice to drain and unplug the hose when not in use to extend the lifetime of the hose.
  • If water is frozen inside the hose, allow several minutes for the ice to melt after plugging in the hose and before use.
  • DO NOT pull or tug the hose with excessive force as this may damage the fittings and electronic components.
  • Download User Instructions En, FR, SP (PDF format)